PROJECT DESCRIPTION This is a custom stainless steel fuel manifold we’ve engineered, designed and built. It’s part Viega press fittings & part welded fittings.
Read More
PROJECT DESCRIPTION This was an MPI (Magnetic Particle Inspection) on a 1.5” thick steel anchor.
PROJECT DESCRIPTION In order to start the hot tub installation, a giant hole had to be cut in order to remove the existing hot tub. Great precision was required to […]
PROJECT DESCRIPTION These stainless steel vent covers were custom designed and fabricated in house to cover air vents located in the back of the boat. These air vent covers were […]
PROJECT DESCRIPTION This hull plate repair was performed on an aluminum hulled vessel. We cut the damaged material from the hull plate and formed new hull plate to be welded […]
PROJECT DESCRIPTION Made from marine grade aluminum, this sea chest and crossover pipe was completely fabricated in-house. Because of the major height restrictions in the engine room, it was necessary […]
PROJECT DESCRIPTION Our customer had an emergency; the port side anchor pocket plate had come lose and bent over the chain while they were on charter in the Caribbean. We flew a crew […]
PROJECT DESCRIPTION Custom hideaway seat for under crew mess table. Made from 316L stainless steel and polished to a mirror finish.
PROJECT DESCRIPTION This was a real challenge. Not only is the transom on a negative angle but it is also heavily curved. Probably why the builder decided against a transom […]
PROJECT DESCRIPTION We designed & fabricated these custom hangers to allow the owner of this large sport-fish the ability to support his tuna tanks on the backside of the swim […]
